Most TimeMaster30s' sold are actually used by professionals who are trying to go on the cheap. Allow the engine to cool before refueling. Avoid creating a source of ignition until the fuel vapors have dissipated. Up to one hour run time 1. Remove the dipstick Figure 12.
The oil level is too high; remove oil from the crankcase. Note: Recycle the battery according to your state and local regulations. The gas cap doesn't seal. Secure the wire so that it does not come into contact with the spark plug. Remove the dipstick and read the oil level on the dipstick; refer to.
Stop the engine and wait for all moving parts to stop. R emo v e the dipstic k Figure 12. Removing the Grass Bag To remove the bag, reverse the steps in Installing the Grass Bag above. The other thing that would make this mower much more easier to maneuver would be pivoting front wheels. Loosen the fastener and remo v e the air filter co v er Y early Figure 30. Note: Tighten the knob firmly by hand.
Note: Spread petroleum jelly on the washout fitting O-ringto make the coupling slide on easier and protect the O-ring. Lift open the side-dischargedeflector Figure 27. Checking for Bent Blades 1. I can feather a steady speed have instant response and the mower is not running away from me. Important: Do not attempt to start the engine with the blade-controlbar engaged; otherwise, you may blow the fuse. Important: Y ou cannot star t the machine with the electric star ter or charge the batter y unless a G017523 w or king fuse is installed.
Other states or federal areas may have similar laws. Indicates that the blade is identified as a part from the original machine manufacturer. Stop the machine if anyone enters the area. Allow the engine to run until it stops. Changing the Engine Oil Service Interval: After the first 5 hours Every 50 hours Yearly Max. Note: Do not brush or blow dirt from the outside of the filter; either forces dirt into the fibers. Move the machine to a level surface.
I had to go to the hardware store to find lock nuts. Wipe off the dipstic k end with a clean cloth. Install the spark plug but do not connect the wire to the spark plug. If you must store the machine in a heated area, you must charge the battery every 90 days. Allow the rope to return to the engine slowly. Rear-deflector and handle-lock lever assembly 8. They have the same engine.
Return the handle to the operating position. Remove the 4 small bolts that hold the rear-deflector and handle-lock lever assembly in place. To reduce the potential for injury, comply with these safety instructions and always pay attention to the safety-alert symbol, which means Caution, Warning, or Danger—personal safety instruction. I loved it when I first used it. Warning—stay away from moving parts, keep all guards and shields in place.
Use at more than one location, or institutional or rental use, is considered commercial use, and the commercial use warranty applies. Note: Ensure that you connect the black negative wire to the negative - terminal and the red positive wire to the positive + terminal. Rear-deflector and handle-lock lever assembly 8. Using an oil can, add about 30 ml 1 oz , of motor oil 1. Do not allow children to operate the machine. While the engine is still warm, change the engine oil; Store the machine in a cool, clean, dry place.